* p6 ?4 ^& b; g我在做金屬切削仿真,，在金屬切削仿真中采用自適應網格,，但是在網格檢查時出現自適應不能使用單元畸變控制！�,�,！7 y4 l2 j* a |- T: A
問題描述如下： 7 l) _: m1 b$ E1 Y: ^Adaptive meshing is not supported for elements used with the distortion control. " c9 d5 M* C/ o5 a# N; L! ZDomain name: assembly_adapt1 N" d7 N, m' d4 A0 ]0 p
Abaqus/Explicit Packager exited with an error - Please see the status file for possible error messages if the file exists.# h0 U2 _ ~2 U; K# H$ P) c
' Y# M( t' d0 A$ m1 f' `; I. ?
但是不用網格畸變控制吧，又出現了網格畸變問題： ) a. Z4 q k8 u+ IThe elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.3 q6 U8 q( {4 s+ z, }& T
The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.$ [ I- X3 U* [( m; U1 W
Print-out suppressed for subsequent distorted elements4 L* M% a: c% @) V* ~/ o
There are a total of 60 excessively distorted elements., F7 X$ _9 \! K7 ^' e0 d, E
請求各位達人幫助,，萬分感謝�,。�,！$ n1 R _9 }0 u4 ^ 作者: 閑庭信步逸 時間: 2019-9-16 16:35
有人回復嗎( R. A7 e2 H; K) i' c s 作者: AdaptER 時間: 2020-3-31 19:55
老哥,，您這個問題解決了嗎？