亚洲欧美日韩国产一区二区精品_亚洲国产精品一区二区动图_级婬片A片手机免费播放_亚洲国产成人Av毛片大全,男女爱爱好爽好疼视频免费,中文日韩AV在线,无码视频免费,欧美在线观看成人高清视频,在线播放免费人成毛片,成 人 网 站 在 线 视 频A片 ,亚洲AV成人精品一区二区三区

機械社區

標題: 求教花鍵軸中的相對角度加工工藝 [打印本頁]

作者: BB7290    時間: 2016-1-26 11:24
標題: 求教花鍵軸中的相對角度加工工藝
本帖最后由 BB7290 于 2016-1-26 11:28 編輯 6 e  j& a7 Y' A- }+ B+ {

7 ^# ?; D2 ]: o% s% K& Y" e6 z6 p如圖,其中兩頭的花鍵相對于中間花鍵的88度,,怎么控制得到?謝謝,。
. h/ Z# Z4 b3 m& X
. D; I# P4 J9 v: x補充:其給的工藝文件上是這樣說明的。2 R- F$ V. r3 M: N
Atention: The tooth gap 34T which is held on the drag fixuture must be painted or marked and it will be the reference to position the gap of the splines in relation to the slot and the thread.% B, S! f5 o9 b- o0 d5 z

+ `3 a* c' P% j6 I" J) k5 PATENTION: Hold the drag fixuture in the centra tooth gap 34T, making one tooth gap 30T coincident to this tooth gap 34T after machining it and in which the drag fixture was held as it is showed at this draft.
6 a$ L2 ^' x( J( r0 o6 J: A+ q
( D/ z8 p5 k) j$ I" oREMARK : Do not take out the drag fixture after machining the first side of the splines and while turning around the piece to machine the second side of the splines to keep the alignment between the splines of the both end sides B and C showed at this draft.
5 j% \9 C  X. F4 `9 H
' ]: i% Y" g0 H7 w8 f& Fatention :End Sides Splines B and C must be aligned within +-10minutes.
! Z  L  B- Z$ z+ a- k
) C0 F. i* A8 a) G! e3 k' ?1 U
0 b* q4 h0 i6 h" J# i% M  x補充內容 (2016-1-26 16:20):
0 S  b& a% N* V' L! X" v& b需對齒的花鍵軸加工
作者: gzzhangxuanlong    時間: 2016-1-26 12:59
坐等高人         




歡迎光臨 機械社區 (http://giwivy.com.cn/) Powered by Discuz! X3.4