金屬切削仿真中采用自適應網格時出現不能使用單元畸變控制

hlhchina

我在做金屬切削仿真,，在金屬切削仿真中采用自適應網格,，但是在網格檢查時出現自適應不能使用單元畸變控制�,。,�,！
+ d2 }1 }9 G( m8 x$ U% i" r問題描述如下：
Adaptive meshing is not supported for elements used with the distortion control.
$ E. z6 h4 S: C/ ]Domain name: assembly_adapt
Abaqus/Explicit Packager exited with an error - Please see the  status file for possible error messages if the file exists.
* n# J% ?2 A" C5 F
但是不用網格畸變控制吧,，又出現了網格畸變問題：
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.
Print-out suppressed for subsequent distorted elements
There are a total of        60 excessively distorted elements.
請求各位達人幫助，萬分感謝�,。,。�

閑庭信步逸

有人回復嗎

AdaptER

老哥,，您這個問題解決了嗎,？