|
|
本帖最后由 hlhchina 于 2011-11-30 21:38 編輯
7 ^, k" t5 q# u o1 u3 L" w0 F$ d+ m- @$ [/ h2 x
我在做金屬切削仿真，在金屬切削仿真中采用自適應網格，但是在網格檢查時出現自適應不能使用單元畸變控制�,。,�,！
: O8 a$ L3 p7 p9 ~ K* A7 u6 c問題描述如下：
' w8 B7 o/ c8 K, Q+ x! [1 I* IAdaptive meshing is not supported for elements used with the distortion control.
$ t1 ]6 U7 i) j' i. _6 E" bDomain name: assembly_adapt
8 X1 Y, D9 \$ S$ S: ]Abaqus/Explicit Packager exited with an error - Please see the status file for possible error messages if the file exists.8 n+ A: j* \* ]7 A% u
$ ?' g; g L. x; D& P/ G/ G f
但是不用網格畸變控制吧,，又出現了網格畸變問題：; ?: A3 `/ t* U) ~9 F! ~
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
S1 K& m0 I3 r$ \' P9 X7 I5 @The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.2 e+ r4 B4 f8 c! [. w; \
Print-out suppressed for subsequent distorted elements. g7 H, x/ q7 K: a5 w* u: w# Z
There are a total of 60 excessively distorted elements.
" a- u, r5 O5 B7 Y" P2 l8 R5 ~1 d請求各位達人幫助，萬分感謝�,。,。�$ J. o8 X0 [# j3 Q: y- d
|
|
發表于 2011-11-30 20:51:21
QQ好友和群
收藏
淘帖
問題專業，描述清楚
伸手黨/灌水/看不懂
